Software Version; Service Messages; Service Utilities - Martin Professional MAC 2000 User Manual

Temperature
→
. 0/ 1 ' & 2 $

Software version

→
. 0/ 1 = & #
briefly at startup.
D!8
The
8 2 9 3

Service messages

The Service LED on the control panel lights under conditions that re_uire fixture service, and there is a
message describing the service re_uired. To display the message, select
item is available only when the LED is lit. There are two service messages.
# & $ 3 ! 6 & ; 3 ! 2 $ ;
life for the HMI -200 W7S lamp. The maximum service life is -25p of the average life, or 940 hours.
/ . 9 ' 5 # & ; 1 = & # : & ! ' 0 > ;
Overheating is typically caused by dirty air filters, fans, or air ventsm incorrect power supply settings, or a
defective fan.

Service utilities

Important! Enter must be held for several seconds to access the utilities menu.
Test seWuences
provides a general test of all effects that can be run without a controller.
' % & ?
routines for circuit board testing that are for service use only.
7eedbacJ toggles
An on-the-fly position correction system monitors the color wheels. If a position error is detected, the shutter
closes while the effect resets. This feature can be disabled by turning effects feedback Z
off.
The automatic pan7tilt position correction system may be temporarily turned off under
off setting, however, is not saved and the system will be re-enabled the next time the fixture starts. If the
system cannot correct the pan7tilt position within -0 seconds, feedback is automatically disabled.
"dOustment
The adXustment menu Z
used by Martin service technicians.
Calibration
The calibration menu Z
mechanical reset or home positions. This allows you to fine tune optical alignment and achieve uniform
performance between fixtures. Dimmer and Voom are calibrated to defined points. The other effects are
calibrated relative to an arbitrary reference fixture.
Default offset settings may be restored by selecting default offsets Z
Calibrating effects
- Apply power and strike the lamp.
provides readouts of the head and base temperature in Celsius and Fahrenheit.
displays the version number of the installed software. The software version is also displayed
menu shows the DMT start code Z
is displayed when the lamp counter exceeds 750 hours, which is the rated average
is displayed when the head temperature exceeds -20\ C Z248\ F[.
→
5 ' . 3 ! " A
→
[ provides utilities to define offsets in software that are relative to the
5 ' . 3 6 ! 3
[ and DMT values received for each effect.
% ' 6 1
[ provides manual control for making mechanical adXustments and is
in the main menu. This
% 2 % >
→
5 ' . 3 $ 6 @ +
5 ' . 3
→
5 ' . 3
→
[.
5 ' . 3 " / 1 /
provides
→
[
& / / )
. The
/ & ) !