Double Flight Case - Martin Professional MAC 2000 User Manual

Double flight case

3npacJing
- Open the flight case and pull the drawer all the way out.
2 Release the head Ztilt[ transport lock.
3 Install rigging hardware as described on page --.
4 With one person on each side, lift the fixture out of the flight
case.
4acJing
- Disconnect the fixture from power and allow it to cool.
2 Turn the yoke parallel to the sides of the base with the tilt
lock closest to the back of the base.
3 Pull the transport drawer all the way out. With one person
on each side, place the fixture on the drawer with the
hFronti arrow pointing into the flight case.
4 Remove and stow rigging hardware. Coil and stow the
power cable in the door.
5 Tilt the head so that the lens points away from the door as
shown in Figure 3. Lock the head in the horiVontal position.
Do not lock the yoke.
6 Slide the drawer all the way in without forcing. Close the flight case.
Setup for flight case testing
The double flight case has two slide-out arms from which the fixture can hang for testing and setting.
Though unnecessary, the pan and tilt reset can be cancelled by pressing jMenuk and jEnterk at the same
time.
- Open the flight case and pull the drawer all the way out. Release the transport locks.
2 Pull the test arms out. Tilt the fixture up and over the test arms so that the handle cross-braces that are
second from the back rest on the arms. The fixture should rest at an angle.
3 Push the transport drawer into the flight case.
Figure 3: Double unit transport position