Is46"Y !.Ss"5.S - Martin Professional MAC 2000 User Manual

D

IS46"Y !.SS"5.S

!essage
#%' ZReset[
%#%' ZSerial reset[
:12&
1$&0;
3&## ZLamp error[
2&## ZMemory error[
%L &# ZShort error[
)'&# ZBase temperature error[
:'&# ZHead temperature error[
/)&$ ZFeedback error pan[
/)&' ZFeedback error tilt[
/)&# ZFeedback error pan u tilt[
$!&# ZPan time-out[
'.&# ZTilt time-out[
6C&# ZCyan time-out[
2!&# ZMagenta time-out[
C&&# ZYellow time-out[
6'&# ZCTC time-out[
6,&# ZColor wheel -[
67&# ZColor wheel 27dimmer
wheel time-out[
B1&# Zqoom time-out[
#@&#
%G%6 ZColor wheel - sensor[
%J%6 ZColor wheel 2 sensor[
%E%6 ZBarn dr. rotation sensor[
%-%6 ZBarn dr. presence sensor[
%M%6 ZYellow7CTC sensor[
%(%6 ZCyan7magenta sensor[
%N%6 Zqoom sensor[
# ! 2 &
1$&#
3'&#
"ppears when...
... the fixture is indexing effects at
startup.
... the fixture has received a reset
command from the controller.
... the effects have been indexed and are
moving to their default positions.
...the lamp access cover is not fully
closed.
... the lamp does not ignite within -0
minutes of receiving a hLamp ONi
command. Probable causes are lamp
missing7defective, or insufficient AC
voltage.
...the EEPROM memory cannot be read.
... the fixture detects the lamp is on but
no hLamp ONi command has been
received. This can occur if the lamp relay
is stuck or if the lamp-power feedback
circuit fails. The fixture may be operated
but remote lamp on7off may be affected.
... there is a fault with the temperature
sensor in the base or head.
...pan, tilt, or both pan and tilt feedback
circuits are malfunctioning. It is still
possible to operate the fixture, although it
switches to nsafeo mode with reduced
maximum speed, thus preventing the
fixture from losing track of its home
position Zlosing step[.
...the electric indexing circuit is
malfunctioning. The fixture will, after the
time-out, establish a mechanical stop,
and continue to work normally.
...the barndoor rotation mechanism is
malfunctioning.
...an effect does not move away from the
index position under reset, a sensor or
micro-switch circuit is short-circuited, or
a micro-switch is stuck or connected
incorrectly.
...there is an onboard RAM memory
error.
...there is an onboard programming error.
...there is a lamp temperature error.
Table 2: Display messages
'hat to do
Wait for reset to complete.
Wait for reset to complete. Set
→
to to prevent
$ & # % " # & % 1 / /
accidental reset commands.
Wait a few moments.
Verify that the lamp access cover is
locked in place.
Check the lamp. Check that the
voltage and fre_uency settings match
the local supply.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Reset fixture. Contact Martin service
personnel if problem continues.
Reset fixture. Contact Martin service
personnel if problem continues.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Contact Martin service personnel for
assistance.
Set fan speed to using the
/ 5 3 3
menu and restart the fixture.
5 ' . 3
Contact Martin service personnel if
problem persists.