C +Ntr+6 4; Navigation; Tailoring Performance - Martin Professional MAC 2000 User Manual

C
+NTR+6 4"N.6
The LED control panel is used to set the address and personalities, read lamp hours and other information,
calibrate effects, and run a test routine. Most of these functions may be performed remotely via the serial
link with the Martin MP-2 Uploader.

Navigation

The DMT address and any messages Zsee page 42[ are displayed when the MAC 2000 Wash is turned on.
To enter the menu, press jMenuk. Press jUpk and jDownk to move within the menu. To select a function or
submenu, press jEnterk. To escape a function or menu, press jMenuk.
See nControl menuo on page 36 for a complete list of the menu items.
Note: jEnterk must be pressed and held for a few seconds to enter the utilities menu.
D!8 address and protocol setting
The DMT address, also known as the start channel, is the first channel used to receive instructions from the
controller. For independent control, each fixture must be assigned its own control channels. Two MAC 2000
Washs may share the same address, however, if identical behavior is desired. Address sharing can be
useful for diagnostic purposes and symmetric control, particularly when combined with the inverse pan and
tilt options.
Two DMT protocols, 8-bit and -6-bit, are available. The 8-bit mode uses -9 control channels and provides
full basic control. The -6-bit mode uses 2 additional channels to provide finer pan7tilt positioning.
Setting the D!8 address and protocol
- Press jMenuk to enter the main menu.
2 Press jUpk until
the desired channel and press jEnterk.
3 Select
$% & '

Tailoring performance

!ovement
The MAC 2000 Wash provides six options for optimiVing movement for different applications. The:
a Protocol setting Z
a Pan and tilt invert Z
a Pan7tilt speed Z
is best for most applications.
0 1# 2
most important.
movements through narrow angles.
a Studio mode Z
a Shortcuts Z
% 6 5 '
static positions or oscillate between outer positions.
TracJing Response
The MAC 2000 Wash has a filter algorithm that looks at several position updates in tracking control mode
and calculates the ideal response for smooth movement. Tracking response is adXustable to compensate for
variations in controller performance. In most cases the default settings work well.
is displayed. Press jEnterk. To snap to channel -, press jEnterk and jUpk. Scroll to
! " " #
from the main menu and press jEnterk. Select
[ setting selects 8-bit or finer -6-bit control of pan and tilt.
$% & '
[ menu swaps and7or inverts pan and tilt.
$ ! ' .
[ menu provides 3 settings:
$ ' % $
/ ! % '
provides the smoothest movement and is best in long-throw applications with slow
% 3 1 4
[ setting optimiVes all effects besides pan and tilt for speed or _uietness.
% ' 5 "
[ setting determines whether the color wheels always take the shortest path between two
or
() * +
, , and
/ ! % ' 0 1 # 2
provides better performance in applications where speed is
and press jEnterk.
, - ) +
.
% 3 1 4