Table of Contents
Advertisement
a. X adjust: According to the previous printing error to adjust the x-axis size.
b. Y adjust: According to the previous printing error to adjust the x-axis size.
● Infill
a. Fill Density: Fill rate.
b. Shell Thickness: To set the shell thickness value between 1mm to 10mm.
c. Infill Thickness: To set the infill thickness value between 0.5mm to 5mm.
● Others
a. Light intensity: According to the sensitivity of light to adjust the light
intensity. Use FlashForge photopolymer resin need not any adjustment, default 100%.
5.2.11 File Menus
① New Project
[File]--[New Project]
Click
modification on previous project, then it will inform you whether the modification
needs to be saved or not. Click
abandon it. If click
[Cancel]
② Saving
After finishing the model edit and adjustment, there are two ways below to save all
models in the scene.
Method 1:
Hunter User Guide | www.FlashForge.com
can build a blank project. If there is an unsaved
[Yes]
will save the modification, while click
or close tool tip, then it will cancel the new project.
5-13
41
[No]
will
400-699-1063
Advertisement
Table of Contents
