Flashforge Hunter User Manual page 39

② Auto Supports
Click the [Auto Supports] button, the software will judge the position where supports
are needed and generate corresponding treelike or linear supports. If it is a model with
supports, the existing supports will be deleted and new supports will be generated.
③ Add Supports
Supports will be added once clicking the [Add] button. Move the cursor to the
position where supports needed, left-click to choose the starting point of supports,
hold down the left mouse button and drag the mouse the supports preview will show
up (if support surface doesn't need support or the support column angle is too large,
will highlight the support review ).Loosen the left mouse button, if support column
doesn't meet with model, then support will be generated on origin and terminal point
(the highlighted preview support won't generate support structure )
④ Clear Supports
Supports], all supports will be deleted. The operation can be repealed
Click [Clear
via clicking [Undo] or pressing the shortcut key Ctrl+Z.
⑤ Delete Supports
Supports will be deleted once clicking the [Delete] button. Move the cursor to the
supports needed deleting, current supports and its subnode support will be highlighted,
click the left mouse button to delete these highlighted support.
Hunter User Guide | www.FlashForge.com 400-699-1063
39