FLASHFORGE 3D PRINTER inventor Quick Start Manual page 4

Unpacking
1.Open the carton and take the lid out. There are
<Quick start guide> / <After-sales Service
Card> / <leveling card and build tap*2>.
4.Remove the packing bag.(Tip:Save your
packaging for future transportation and
storage.)
2.Take the two foam sheets out from the top.
5.Take foam out of the box.
3.Firmly grasp the two sides handles of Inventor.
Lift it out from the carton and place it on a
stable surface.
6.Open box. Box includes dual extruder, side
panel*2, extruder's accessory kit. Take the
dual extruder out and place it onto a clean
ground. Notes: Extruder wire harness is short,
please do not hanging the extruder in the air.