Advertisement
Place filament and loading filament
(1)Unpacking filament.
(2)Place filament on spool lock on both sides.
TIPS
Make sure correction direction when filament place
on spool lock. As shown on the right picture.
(1)Shown as below, put spool lock into center hole of
filament and then rotate 90 degree to make sure its
locked. Rotate to negative direction to pull it out.
Notes: Opposite rotation to place filament on
respective spool lock.
Correct Direction
Stand on leftspool lock
Stand on rightspool lock
Wrong Direction
Guide Wire
Advertisement
Need help?
Do you have a question about the inventor and is the answer not in the manual?
Questions and answers