First Print - FLASHFORGE 3D PRINTER inventor Quick Start Manual

7

First Print

(1) Insert SD card into SD card slot which on the right side of printer.
(2) Select [Print]-click SD car figure, click first 3D modeling file, select
[print]. Once heated, the printer will start printing automatically.
Notes: The model file in SD card has been set, it can be printed directly.
The "L" after the filename represent use Left exdruder to print,
"R" represent use right extruder to print.
NOTES
1. Load the filament for a while to extrude the melted filament out of the extruder that you printed last time.
2. Do not leave the Inventor unattended during operation.
3. If needed, gently use the scraper to remove the object from build plate to avoid damaging the objects and build plate. If desired,
heat the build plate to 40~50℃
to separate the object from the build plate.
4. Please preheat the heating plate to 50-70℃ for printing with PLA.
1
Print Preheat Tools
3
DM-test-L
DM-test-R
DM-40mmCUBE-L
DM-40mmCUBE-R
2
4
DM-test-L
Print Time: 4:01
Copy
Print
Delete
DM-test-L
Print Time 0：01
0%
30℃ / 210℃
L Extruder
R Extruder 30℃
30℃ / 50℃
Platform