QuickLabel Kiaro! 200 User Manual page 31

Kiaro! 200 User Guide
• Configure the printer for DHCP or a static IP address.
Ensure the printer has been in the "Ready" state for at least 30 seconds before
attempting to connect via DHCP or static IP address. Additionally, if you
change the selection from static IP address to DHCP, wait at least 30 seconds
before proceeding to allow the printer to establish DHCP communication.
• Select an installation location for the Kiaro! 200 Maintenance Utility when
prompted.
Choose Finish in the installation wizard after successfully installing the Kiaro! 200
Maintenance Utility and driver.
Quick Start Guide
17