Table of Contents
Advertisement
Jump starting
Jump start assistance
P54.10 2749 31
1
Positive terminal of your own car
2
Negative terminal of the other battery
3
Positive terminal of the other battery
4
Negative terminal of your own car
> Turn off the engine of both vehicles.
> Put the gearshift lever to N.
> Switch off all electrical consumers.
> Remove the battery cover.
230
>> Practical advice.
> Connect the positive terminals
with the red jumper cable. Start with your
own battery
1
.
> Connect the negative terminals
the two batteries with the black starter ca
ble. Start with the battery
ting vehicle.
> Allow the engine of the assisting vehicle to
idle.
> Start your own car's engine.
> If the engine does not start immediately,
wait about 60 seconds before making ano
ther attempt.
If the engine will not start, call a breakdown
recovery service, e.g. smartmove Assis
tance, or a qualified specialist workshop
such as a smart center.
Removing the jumper cables
1
3
and
> Do not switch on electrical consumers such
2
4
and
of
as the blower or the rear window heater un
til the engine is running.
2
of the assis
Do not switch on the lights!
This helps reduce the danger of any spar
king when removing the jumper cables.
> Let the engine run for two to three minutes
until it is running smoothly.
> Disconnect the jumper cable from the nega
tive poles
with your own battery
> Disconnect the jumper cable from the posi
tive poles
> Have the battery checked by a qualified
specialist workshop such as a smart center.
2
and
4
of the batteries. Start
4
.
1
and
3
of the batteries.
Advertisement
Chapters
Table of Contents
