Adjusting Head Height - MUTOH Falcon Outdoor Jr. Operation Instructions Manual

4.5. ADJUSTING HEAD HEIGHT.

Depending on the media type and media thickness used, it is possible to adjust the printer's printhead height
accordingly 1.5 mm to 2.0 mm (± 0.15 mm).
The head height can be adjusted using the lever on the left side of the head (please refer to the picture
mentioned above).
When the lever is put in horizontal position (turn counter clockwise) the head is in his highest position : 2.0
mm
When the lever is turned clockwise, the head is in his lowest position : 1.5 mm.
The lever can only be put in two positions, there are no intermediates.
Typical use :
LOW
Photo quality output on photo paper type media
(Mutoh Photo Great Piezo Media, Paper, Vinyl,
Synthetic paper,...)
Falcon Outdoor Jr. – Operation Instructions
HIGH
Thick media or media with fibres (Fabrics) which may
touch the printhead during printing.
(Canvas, Art Paper, Cardboard,...)
Page
53
PN: MAI-75039
Rev. 1.A – 07/26/05