Hardware Installation; Installing The Access Point - Gemtek Systems P-780 User Manual

P-780 User's Guide v1.2

Hardware Installation

Installing the Access Point

Use the following procedure to prepare your network connection to P-780.
Use the enclosed POE and power cord or any others IEEE802.3af Compliant POE
Power Source Devices to supply your P-780 Access Point.
Step 1 Assemble part 1 of the Mount Kit at the back of the bottom cover as shown in the following
figure:
Figure 5 – Assembling the Mounting Kit to the P-780
Step 2 If you are mounting the AP on the wall, first install the bracket 2 of the mounting kit to a
suitable position. Assemble the back of the P-780 case to the bracket ubsequently.
Step 3 If you are mounting the AP to a mast, first install the bracket 2 and the clip 3 of the
Mounting to a mast. Assemble the back of the P-780 case to the bracket subsequently
Step 4 Assemble the one side of a Ethernet twist cable with the waterproof RJ45 connector .
Gemtek Systems
February 7, 2005
Page 15 of 60