Emerson EV1000-2S0004G User Manual page 71

Para. Name
Displayed
F8.03 Parameter at Stop
state
Rotating speed
F8.04
display factor
F8.05 Line speed factor
Close-loop analog
F8.06
display factor
Para. Name
Operating command bundled
F9.00
with freq. setting method
Group 8: Display Control Parameters
Binary code implication:
0: not displayed
1: displayed
One's place
BIT0: reference frequency ( Hz)
BIT1: external counter value (no unit)
BIT2: rotating speed (r/min)
BIT3: preset rotating speed ( r/min)
Ten's place:
BIT0: actual line speed ( m/s)
BIT1: preset line speed ( m/s)
BIT2: VCI ( V)
BIT3: CCI ( V)
Hundred's place of LED:
BIT0: Analog close-loop feedback (%)
BIT1: Analog close-loop setup (%)
BIT2: actual length
BIT3: preset length
Thousand's place:
BIT0: terminal state (no unit)
BIT1: bus voltage
BIT2: accumulated length
Note: if the setting is 0, the default display is operating freq. before
compensation.
0.1~999.9%
Mechanical speed=measured speed × F8.04 ( PG)
Mechanical speed =120 × actual freq.÷FH.00 × F8.04 (non-PG)
Preset speed=preset close-loop speed × F8.04 (PG)
Preset speed=120 × ref. Freq.÷FH.00 × F8.04 (non-PG)
Note: it has no effect on actual speed.
0.1~999.9%
Line speed=actual freq. × F8.05 (non-PG)
Line speed=mechanical speed × F8.05 ( PG)
Preset line speed=preset freq. × F8.05 (non-PG)
Preset line speed=preset speed × F8.05 ( PG)
Note: it has no effect on actual speed.
0.1~999.9%
Note: close-loop analog input/feedback display range: 0~999.9
Group 9: Enhanced Function
One's place: in keypad control mode
0: no binding
1: digital setting 1 (adjust by ▲ and ▼ key)
2: digital setting 2 (adjust by terminal UP/DN)
3: digital setting 3 (adjust by serial port )
4: VCI analog setting
5: CCI analog setting
6: Terminal puse setting
7: Potentiometer
Ten's place: in terminal control mode
0~7: the same with the above.
Hundred's place: in serial port control mode
0~7: the same with the above.
EV1000 Series General Purpose Variable Speed Drive User Manual
Range
Range
Appendix 1 Parameter Set
Unit Default
1 1FF
0.1% 100.0%
0.1% 1.0%
0.1% 100.0%
Unit Default
1 000
69
Modification
○
○
○
○
Modification
○