Speed Setting; Locking/Unlocking Keypad - Emerson EV1000-2S0004G User Manual

Under menu level 3, if no digit of a parameter is blinking, it means it is unchangeable. The possible reasons are:
The parameter is unchangeable, such as measured parameters, operation log, etc;
The parameter can be changed at stop state only;
The parameter is protected. When FP.01=1 or 2, the parameter is protected. You should set FP.01=0 to allow the modification.

4.2.5 Speed Setting

If the initial state is actual speed, set speed, actual line speed or set line speed, you may press ▲ or ▼key to change the set
speed and set line speed real-time. If you want to change the reference setting, press
frequency then change it.

4.2.6 Locking/Unlocking Keypad

Lock Keypad: Set the hundred's place of F9.07 at non-zero value. Press FUNC/DATA key and PRG key at the same time, thus
the keypad is locked.
Unlock: at stop or operating state, press FUNC/DATA key, and then press ▼ three times. Note that the operation will not
change the value of F9.07.
Note:
Even though the hundred's place of F9.07 is not zero (allow to lock the keypad) , every time the drive is powered up, the keypad is not
locked.
Thousand Hundred Ten one
PRG
50.00
00 20 0020
FUNC
DATA
0120 F9.08
Figure4-2 Lock LED keypad display unit
EV1000 Series General Purpose Variable Speed Drive User Manual
BIT0: output freq. (before compensation)
BIT1: output freq. (after comensation)
BIT2: set freq.
BIT3: output current (A)
BIT0 ：actual speed (rpm)
BIT1：set speed
(rpm)
BIT2：actual line speed (m/s)
BIT3：set line speed (m/s)
BIT0：output power
BIT1：output torque (%)
BIT2 ：reserved
BIT3 ：reserved
BIT0 ：reserved
BIT1：reserved
BIT2：reserved
BIT3：reserved
FUNC
DATA
F0 -F9-
FUNC
DATA
F9.07
PRG
-F9-
FUNC
DATA
+
50.00
Chapter 4 Operation Procedures
key to shift the LED display to
F9.00
50.00
PRG
23