Placing Your Appliance - Pelpro PP60 Owner's Manual

Installing Your Appliance

Placing Your Appliance

It is necessary to install EMBER PROTECTION; a Type
1
I floor protector for this appliance.
The Floor protector must be non-combustible material, extend-
ing beneath appliance with a minimum of 6 inches (152mm) in
front of glass and 6 inches (152mm) to both sides of the fuel
loading door. Open the door and measure 6 inches (152mm)
from the side edge of the opening in the face of the appliance.
Notice: Be careful to protect the bottom of the appliance
and floor surfaces when moving the appliance. Bottom
edges of appliance are sharp and can scratch surfaces.
Notice: Clearances may only be reduced by means
approved by the regulatory authority having jurisdiction.
Hearth pad minimum requirements:
2
USA Hearth Pad Requirements
A
B
C
Canada Hearth Pad Requirements
A
B
C
Non-combustible floor protection extending beneath the flue pipe is required
with horizontal venting or under the top vent adapter with vertical installation.
*Non-combustible floor protection must extend 2 inches (51mm) beneath the
flue pipe when installed horizontal venting or under the top vent adapter with
vertical installation. CANADA REQUIRED, USA RECOMMENDED.
Confirm required clearances to combustibles:
3
Vertical Installations (Interior Flue)
Straight back against wall
D Back wall to pellet pipe
E Side wall to appliance
Straight back against wall
F Walls to appliance
Horizontal Installations
Straight back against wall
G Back wall to appliance
E Side wall to appliance
pelprostoves.com
Inches
Sides 2
Back 2
Front 6
Inches
Sides 8
Back 2
Front 6
Inches
3
13
Corner Installation
Inches
3
Inches
2
13
PelPro Cast Pellet Stove • 7083-171N • 9/8/17
1
2
mm
51
51
152
3
mm
G
203
51
152
F
mm
254
330
mm
76
mm
51
330
B*
A A
C
D
E
F
9