Venting Your Appliance - Pelpro PP60 Owner's Manual

Hide thumbs Also See for PP60:
Table of Contents

Advertisement

Installing Your Appliance

Venting Your Appliance

CAUTION!
Take appropriate precautions to locate utilities within the wall and avoid contact.
1
Mark and cut wall for venting penetration on exterior wall (if needed).
2
Install wall thimble (sold separately) per manufacturer requirements.
Install venting. (For additional installation options visit pelprostoves.com)
3
4
Use silicone to create an effective vapor barrier at the location where the chimney or
other component penetrates to the exterior of the structure.
Vertical - Interior, Preferred Installation
Flashing
Firestop
Ceiling Support
6 in.
(152mm)
Min.
NOTE: In Canada when using a factory-built chimney it must be safety listed, Type UL103 HT (2100 o F) CLASS "A" or
conforming to CAN/ULC-S629M, STANDARD FOR 650 o C FACTORY-BUILT CHIMNEYS.
Pro Tips
See venting manufacturer's required clearances to combustibles
For horizontal installations, the minimum clearance from exterior to termination cap is 6"—you
may want to increase to 18" clearance to minimize soot blow back on home exterior.
Install vent at clearances specified by the manufacturer
WARNING!
Do not terminate venting in any enclosed or semi-enclosed area
such as: a carport, garage, attic, crawl space, under a sun deck
or porch, narrow walkway or closely fenced area, or any location
that can build up a concentration of fumes such as a stairwell,
covered breezeway, etc.
10
Rain Cap
12 in. (305mm) Minimum
Follow pipe manufacture
listed clearance
Clean-out T
RELEASED
Non-combustible Hearth Pad
PelPro Cast Pellet Stove • 7083-171N • 9/8/17
Exterior - Optional Installations
Wall Thimble
RELEASED
6 in. (152 mm)
Minimum
Non-combustible
Hearth Pad
11.75
CAUTION!
Ensure that your appliance venting terminates
above your appliance. The following may occur:
• Your appliance appliance will not draft properly
• Smoke may seep in your house
• Excessive sooting
Termination
Cap
6 in.
(152 mm)
Minimum
Wall Thimble
Horizontal
ITEM
PART NUMBER
Termination Cap
-
----
-----
6 in.
(152 mm)
Clean Out T
Minimum
RELEASED
11.75
pelprostoves.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents