Charging The Rc9800I - Philips rc9800i User Manual

RC9800i Touch Screen Remote Control - User Manual

Charging the RC9800i

Philips Innovative Applications
Cursor: Up-Down-Left-Right and OK hard keys. The action resulting from
pressing the cursor depends on what is shown on the touch screen. In
general the cursor keys allow you to navigate around.
The Up and Down hard keys can be either partially or fully pressed:
Partially: To move through a list one item at a time, partially press the
up or down key.
Fully: To move quickly through a list, fully press the up or down key.
If you fully press and hold the keys for more than 5 seconds, the
highlight will jump to the top (or bottom) of the list.
The OK hard key in the middle of the cursor is used to confirm a selection
and to trigger the corresponding action.
Page: Press this hard key to cycle through several screens in a loop. When
only one page is available, the Page hard key is inactive.
Back : To quickly move back through the series of screens that you have been
viewing, press the Back key. For more information see Error! Reference
source not found. on page Error! Bookmark not defined..
Home: Press this hard key to return to the Homepage.
The battery level of the RC9800i is displayed on the touch screen. At any time
you can charge the device as follows:
Plug the power adapter into the cradle.
Dock the RC9800i in the cradle.
The RC9800i is being charged and an animation of the battery icon
appears on the touch screen.
It takes about 3 hours to fully charge the RC9800i.
When the RC9800i is in standby mode, the battery lasts for approximately 2
weeks. However, we advise you to recharge the device frequently.
Note
When the RC9800i is in standby mode, it will beep from time to time to
inform you that the battery is getting low.
Pick Up Your RC9800i and Take a Good Look
Page 15 of 39