Charging The Control Panel; Enjoying Your Pronto Control Panel; Controlling Your Home Theatre - Philips TSU9300 Starter Manual

TSU9300 Starter's Guide

Charging the Control Panel

When the Battery level icon
Depending on how your installer has configured the Control Panel, it can be operated for one or up
to several days.
Note The lifetime of the battery depends on the time-out settings and the settings of the wireless
network configured by your installer. If you notice that the battery is deteriorating, please
contact your installer.
When you place the Control Panel in the docking station, an LED
will light up, indicating that the Control Panel is being charged.
When the LED goes off, the Control Panel is fully charged.
This can take 3 to 4 hours.
When the battery is low and the Charging LED is not visible,
make sure that:
• the Control Panel is placed properly in the docking station.
• the power switch on the left side of the Control Panel is switched to "1".
• the docking station is plugged into the wall socket.
• the connector in the docking station is clean and free of obstructions.
Tip It is advisable to place the Control Panel in the docking station after use. Even when the screen of
the Control Panel turns black, the Control Panel is still using power.

Enjoying your Pronto Control Panel

Controlling your Home Theatre

Activating the screen of the Control Panel
• Tap the touchscreen with your finger.
-Or-
• Press the Backlight key.
4
on your screen turns red, it is time to charge the Control Panel.