Getting The Settings Right; Rc9800I Settings; Calibrating The Touch Screen - Philips rc9800i User Manual

RC9800i Touch Screen Remote Control - User Manual

Getting the Settings Right

RC9800i Settings

Philips Innovative Applications
When starting the RC9800i for the first time, a screen appears to welcome you
to the initial startup sequence. During this sequence, a wizard will guide you
through the initial set-up screens. The wizard prompts you to perform the
following actions:
Going through the RC9800i settings:
Calibrating the touch screen: see page 17.
Selecting your Location: see page 18.
Entering the RC9800i's Network information: see page 18.
Entering information concerning Date/Time Zone.
Going through the Home Setup:
Room Setup;
IR Extender Setup;
Device Setup
Going through the Activity Setup.
Note
You can exit the initial set-up Wizard at any time by clicking Exit on a screen.
However, you can run the initial setup only once. Afterwards you can change
settings as explained in Error! Reference source not found. beginning on
page Error! Bookmark not defined..
To navigate through the initial Setup, you can use the soft buttons Back and
Next.
Attention!
Before you proceed, we advise you to fully charge your RC9800i.

Calibrating the Touch Screen

On first use you have to calibrate the RC9800i 's touch screen. Afterwards,
you can calibrate the touch screen any time you like to improve its accuracy.
When you activate your RC9800i for the first time the following screen
appears:
Please carefully press the center of
the crosshairs to calibrate your
touchscreen.
Getting the Settings Right
Page 17 of 39