Installing The Docking Station; Charging The Remote Control - Philips Pronto TSU9200 Starter Manual

1.2

Installing the Docking Station

Turn the docking station upside-down.
1
Plug in the wire as shown.
2
Press and twist the wire into place.
3
Plug the adapter of the docking station into the wall outlet.
4
1.3

Charging the Remote Control

When the Battery level icon
charge the Remote Control. In normal conditions, the Remote Control can be operated for
several weeks.
When you place the Remote Control in the docking station, the red Charging LED
on the front of the docking station lights up.
D Note
If the docking station does not light up, the Remote Control
is not placed correctly in the docking station and it will not charge.
When the Charging LED fades out, the Remote Control is fully charged.
This can take 3 to 4 hours.
E Tip
It is advised to place the Remote Control in the docking station after use so that you can
always locate it easily.
Getting to Know Your Pronto Remote Control
TSU9200_END_EN-ES-FR.indb 5
1
2
3 4
1
3
on your screen turns red and starts blinking, it is time to
2
4
5
14-09-2007 12:04:57