Belling 487 Installation And User Instructions Manual page 7

IMPORTANT
1. General
2. Oven Unit
Housing
Cabinet
3. Final
Installation
List of Loose
Items
Installation Instructions
It is essential that the lower cupboard is constructed in the manner
illustrated i.e. having side, back and roof panels so joined as to provide no
apertures which could permit access to the oven unit when installed.
The appliance is designed for mounting at a safe level into an oven
housing which must be secured.
a. The oven housing unit cabinet dimensions must comply with
Fig. 4.
b. An air gap of 50mm minimum must be provided at the rear of
any top or bottom cupboards or shelves. Fig 1.
c. It is necessary that the cabinets are provided with unobstructed
ventilation, i.e. from adjacent cabinetry. This can be done by either raising
the base of the cabinets using the adjusting feet(or spacers) or
alternatively by providing a slot in the cabinet plinth to the dimensions
shown in Fig. 1.
d. The air gap at rear allows the warmed air to pass out of the inner
cabinet space, but where it is intended to fit cupboards above
the oven unit to ceiling height it is essential that the warmed air
is exhausted through the front of the cabinet Fig. 1.
e. If an oven unit is installed adjacent to a tall cabinet, steam
escaping from the oven when the door is opened could
condense on, and perhaps stain the adjacent surface. To prevent
permanent staining the adjacent surface should be made of a material
that is heat resisting and easy to clean. Adjacent tall cabinets should not
be deeper than the oven housing cabinet.
a. Using a spirit level, check that the housing cabinet is level from
side to side and from front to back in its installed position.
b. Correct any unevenness by placing spacers under the bottom of
the cabinet. Make sure that the cabinet rests firmly on the floor
without rocking.
c. Before the oven is fitted the cabinet must be firmly secured to
the backing wall for stability.
d. The oven unit should now be lifted (this is a two person lift) into
the cabinet and pushed fully home.
e. Finally the oven is secured to the cabinet by means of the four
pozi washer head screws, two through each side trim.
f. Remove all packing material from the grill and oven interior.
4 x Pozi Washer Head No. 6 x 15mm screws.
7