Belling 487 Installation And User Instructions Manual page 35

To Clean the Inside
of the Outer and
Inner Glass Panels
Fig.1
Care and Cleaning
TURN OFF THE COOKER ELECTRICITY SUPPLY AND ALLOW THE
APPLIANCE TO COOL BEFORE CLEANING.
1. Position the top or bottom door as shown (Fig.1)
Note: The door can be wedged open using a towel between the door and
the side trim thus leaving your hands free.
2. Grip inner door panel and handle/outer glass assembly. Remove two
screws and fibre washers (put to one side) as shown (Fig.2)
3. Pull handle/outer glass assembly at the top, outwards while still
holding the inner door panel and unhook handle/outer glass assembly
at the bottom by lifting handle/outer glass assembly upwards, as
shown (Fig.3)
Take care not to dislodge rubber grommets in bottom of the door.
4. Return the inner door panel to the closed position as shown (Fig.4)
WARNING: Care must be taken when closing the door inner panel as the
door will attempt to snatch shut, without the weight of the handle/outer
glass assembly avoid trapping your fingers.
5. The inside of inner and outer door glass can now be cleaned using a
clean, damp cloth and then polished using a clean, dry cloth.
6. Refit the handle/outer glass assembly by opening the oven door and
hold, taking care not to trap your fingers (see Fig.3). Hook the
handle/outer glass assembly back into the rubber grommets at the
bottom of the inner door (see Fig.3). Fit the handle/outer glass
assembly back in position at the top ensuring the fixing tags on the
handle/outer glass assembly fit inside the door inner panel. While still
holding the door together, refit the two screws and fibre washers (see
Fig.2).
WARNING: Never operate either oven without the outer glass panels
correctly refitted.
Two screws
and washers
Fig.2
Door Fixing Tag
Fig.3
Rubber
Grommets
Door Inner Panel
Door Outer Glass
and Handle
Fig.4
35