Belling 487 Installation And User Instructions Manual page 17

To Set Timer To Switch ON and OFF Automatically (cont.)
16.20
Other Notes On Timer Operation
1. When cooking Automatically the cook period can be checked at any time simply
by pressing the "
2. When cooking Automatically the Stop time can be checked at any time by simply
pressing the "
step 4 above.
3. Having set a cooking period and Stop time an electronic device stores the
information. The device within the timer will switch the oven on at the required
start time.
4. If a mistake is made and is not readily rectified alter the cook period to show
(as per Step 3 above) then press the "
and start the sequence again.
5. After an Automatic sequence the bleeping sound could also be switched off
by pressing any of the three buttons
However the cooker cannot be re-used until the timer has been set to manual
operation, this is achieved by pressing the "
6. If at any time the display shows three flashing zero's 0.00 . It is likely that the
electricity supply to the oven has been interrupted. Reset the timer to the correct
time of day. Food in the oven may therefore not have been cooked, before serving check
food is thoroughly cooked.
7. To give yourself more time to set each function press and hold the required
function button and at the same time press "+" or "–" button.
NOTE: Between the hours of 10.00p.m. and 6.00a.m. the intensity of the display reduces.
Oven Timer Operation
The oven will no longer operate until the timer has
been reset to manual operation.
Step 6
Turn off the oven control and selector switch.
Step 7
Press the "
sound. (If 2 minutes has not elapsed.)
Press "
"Manual Operation".
" button.
" button. (This also can be altered at any time by following
" button to cancel the bleeping
" button again to return oven to
" (see Step 7 above)
( , , ).
" button (see Step 7 above).
17