Updating The Mapping List With The New Psu Trackid - Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual

Applicant: Motorola Solutions
3 Connect the power supply cables and optional backup battery cables (AC in, DC in / battery).
4 Connect remaining cables according to labels attached before PSU removal.
5 Switch ON the Power Supply Unit.
6 Check the LED indicators to verify the PSU is operating correctly. See MTS LiTE, MTS 2 and MTS 4 Installation,
Configuration and Basic Service Manual.

Updating the Mapping List with the New PSU TrackID

Procedure:
1 Log on to the Site Controller.
2 Use the following MMI command to view the mapping list: can check_mapping.
Step example:
SC> can check_mapping
Units are present:
Device Track ID
DPM 1 JTH0500101
DPM 2 JTH0500105
Units are not present:
PSU 1 JTH0500200
Track ID not mapped:
JTH0500102
3 On the list, locate the unit that you have removed and that is indicated as Units are not present.
4 Delete old CAN Bus unit from the CAN Bus unit mapping list. Use can remove_mapping <Device>,
where <Device> is the old unit name.
Step example:
SC> can remove_mapping psu 1
5 Add new CAN Bus unit to the CAN Bus unit mapping list.
Use can add_mapping <Device><TrackID>, where <TrackID> is a Track ID of the new unit and
<Device> is the new unit name: psu X, where X denotes a digit between 0 and 2.
Step example:
SC> can add_mapping psu 1 JTH0500102
6 View the updated mapping list using the can check_mapping command and check that there are no units
labeled as Track ID not mapped or Units are not present .
Note: The new unit Track ID is present on the replaced unit label and indicated as Track ID not
mapped in the list shown in step 2.
6802800U74-AD | September 2014 |
Equipment Type: ABZ89FC5827 / 109AB-5827
Power Supply Unit | 303
Send Feedback
Exhibit D2