Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual page 68

Applicant: Motorola Solutions
240 | Radio Frequency Distribution System
Reinstalling the MTS LiTE / MTS 2 Duplexer
Procedure:
1 Insert the Duplexer into the filter tray.
See Inserting the MTS LiTE / MTS 2 Duplexer into the Filter Tray on page
2 Update the mapping list with the new unit TrackID.
See Updating the Mapping List with the New Unit TrackID on page
Inserting the MTS LiTE / MTS 2 Duplexer into the Filter Tray
Procedure:
1 Slide the Duplexer into the filter tray in the cabinet. Make sure the rear center tab fits in the appropriate slot.
2 While supporting the Duplexer fasten the two screws at the front.
3 Fasten screw in the center tab behind the antenna.
4 Attach all RX, TX and signal cables to be connected to the Duplexer. Fasten the antenna cable.
5 Switch ON the Power Supply Unit.
Updating the Mapping List with the New Unit TrackID
Procedure:
1 Log on to the Site Controller.
2 View the mapping list by entering: can check_mapping.
Step example:
Units are present:
Device Track ID
DPM 1 JTH0500101
PSU 1 JTH0500200
Units are not present:
DPM 2 JTH0500105
Track ID not mapped:
JTH0500102
3 On the mapping list, locate the removed unit indicated as Units are not present.
4 Delete the old CAN Bus unit from the CAN Bus unit mapping list by entering: can remove_mapping <X>.
<X> identifies the old unit name and is digit between 0 and 3.
Step example: can remove_mapping dpm 2.
5 Add the new CAN Bus unit to the CAN Bus unit mapping list by entering: add_mapping dpm<X><track
ID>.
<track ID> is a Track ID of the new unit.
<X> identifies the new unit name and is a digit between 0 and 3.
Step example: can add_mapping dpm 2 JTH0500102
6 View the updated mapping list by entering: can check_mapping.
7 On the mapping list, check that there are no units labeled as Track ID not mapped or Units are not
present.
Send Feedback | September 2014 | 6802800U74-AD
Note: The new unit Track ID is present on the replaced unit label and indicated as Track ID not
mapped.
Equipment Type: ABZ89FC5827 / 109AB-5827
240.
240.
Exhibit D2