Motorola DIMETRA MTS 4 Installation, Configuration, And Service Manual page 83

Applicant: Motorola Solutions
To prevent accidental contact with high energy and injury to personnel, switch off the Power Supply Unit.
2 Remove the door of the cabinet completely.
3 Remove the three screws fastening the Cavity Combiner to the brackets of the cabinet.
Two screws are on the left and one is on the right side of the Cavity Combiner.
4 Remove all TX and signal cables.
5
Slide out the Cavity Combiner.
Reinstalling the Cavity Combiner
Procedure:
1
Insert the Cavity Combiner into the cabinet.
See Inserting the Cavity Combiner into the Cabinet on page
2 For redundant ATCC only: Upgrade the redundant ATCC firmware.
See Upgrading the Redundant ATCC Firmware on page
3 For ATCC only: Update the mapping list with the new unit TrackID.
See Updating the Mapping List with the New TrackID on page
Inserting the Cavity Combiner into the Cabinet
Procedure:
1 Slide the Cavity Combiner into the cabinet.
2 Attach the TX and signal cables.
3 Fasten the three screws that hold the Cavity Combiner onto the brackets of the cabinet.
Two screws are on the left and one is on the right side of the Cavity Combiner.
4 Put the door of the cabinet back on.
5 Switch on the Power Supply Unit.
Upgrading the Redundant ATCC Firmware
Procedure:
1 Connect a PC with the TFTP server to the Base Station.
2 Place the new firmware on the TFTP server.
3 Log on to the Site Controller.
4 At the command prompt, enter:
tftp <IP address> get <tftp server directory>\SU11075-15.a90 /ffx/
SU11075-15.a90
The firmware is transferred from the PC to the Base station.
5 Load the file into the ATCC by entering atc 1 load_program /ffx/SU11075-15.a90 .
The firmware is loaded to the ATCC and the upload status displays.
6 Verify the successful upgrade by entering atc 1 get device_id.
The device ID matches the firmware version.
Caution: The Cavity Combiner can weigh up to 11.8 kg (26 lbs.). Use caution when removing or
installing Cavity Combiner into the equipment rack. To avoid injury to personnel and equipment
damage, ensure that the combiner is fully supported when free from mounting rails.
Caution: The Cavity Combiner can weigh up to 11.8 kg (26 lbs). Use caution when removing or
installing Cavity Combiner into the equipment rack. To avoid injury to personnel and equipment
damage, ensure the combiner is fully supported when free from mounting rails.
Equipment Type: ABZ89FC5827 / 109AB-5827
Radio Frequency Distribution System | 255
255.
255.
256.
6802800U74-AD | September 2014 | Send Feedback
Exhibit D2