Receive; Monitor; Repeater/Talk Around - HYT TC3600 Manual

3. Make sure there is no activity on the channel.
4. Press the PTT button and speak into the microphone with your mouth 1- 2 inches
away from the radio. The LED glows red during transmission.
5. Release the PTT button to finish transmission.

Receive

1. Turn on the radio.
2. Rotate the "Channel Selector" knob to select the wanted channel.
3. Adjust the volume.
4. If vibration mode is set and a call is received, the radio will alert you with vibration
and no audio will be heard. The LED glows green during receiving.
5. When CTCSS/CDCSS or squelch tail elimination feature is set by your dealer:
•
No squelch tail will be heard at the end of a received transmission when the
courtesy tone is disabled.
•
A beep tone sounds at the end of a received transmission when the courtesy tone
is enabled.
Please contact your dealer for more details.

Monitor

1. Press MONI key to monitor the current channel.
2. Press MONI key again to exit.
3. Your dealer can set three monitor modes: Selective call monitor, CTCSS monitor
and Carrier monitor.
Selective call monitor: To prohibit selective call squelch;
CTCSS monitor: To prohibit all signaling squelch and open the speaker when carrier is
detected.
Carrier monitor: To prohibit all squelch and open the speaker.

Repeater/Talk Around

When you are out of the communication range of the repeater and within the
communication range of your group member, you can bypass the repeater and talk
directly to your group member.
Press the programmed "Repeater/Talk Around" key to select between "repeater" and
17