Table of Contents
Advertisement
The Rx/Tx frequency on each channel is set by your dealer.
Press the [Channel Up] key (programmable) to select a higher numbered channel; press
the [Channel Down] key to select a lower numbered channel.
Receive
If CTCSS/CDCSS, 2-Tone has been programmed on the current channel by your dealer,
you can receive calls with matched tones or codes only. If CTCSS/CDCSS, 2-Tone is not
set, you can hear from all the users on the same channel.
Transmit
1. Hold down the [PTT].
2. Dial DTMF number via microphone keypad. (This operation may be unnecessary).
3. Speak into the microphone. The LED is red while calling.
4. Release the [PTT] to return to the receive mode.
5. When transmission ends, put the microphone on hook.
Programmable Power Output
If the current channel is programmed with high power by your dealer, the power output
toggles between high and low upon each press the Tx Power Select key (programmable).
Low power is for battery saving and avoiding interference with other users, low power is
recommended when communication within limited range.
Note:
If the current channel is programmed with low power, press the Tx Power Select key,
an error alert tone is heard while the power output will not change.
If you switch to low power on a channel that was set with high power, this
configuration is done on all other channels that were set with high power.
BOT ID and EOT ID
Your dealer may configure whether to transmit Connect ID (BOT ID) and Disconnect ID
(EOT ID), when connecting or disconnecting a repeater or telephone system. The
following modes are programmable:
1、BOT ID occurs on each press of [PTT].
EOT ID occurs on each release of [PTT].
2、Press the [*] while holding down the [PTT], then BOT ID is transmitted.
Pres the [#] while holding down the [PTT], then EOT ID is transmitted.
第 17 页 共 31 页
Advertisement
Table of Contents
