Display Spbm Bridge - HP FlexFabric 5930 Series Command Reference Manual

Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
vlan-id: Specifies a B-VLAN ID in the range of 1 to 4094. If you do not specify a B-VLAN ID, the
command displays ECT algorithm information for all B-VLANs.
standby slot slot-number: Specifies a subordinate device by its IRF member ID. If you do not specify a
subordinate device, the command displays information for the master device.
Examples
# Display ECT algorithm information for all B-VLANs.
<Sysname> display spbm b-vlan
B-VLAN 1:
Mode: SPBM
Local use: Yes
ECT-Index: 1
I-SID list: 300-302, 305, 309
B-VLAN 2:
Mode: SPBM
Local use: Yes
ECT-Index: 1
I-SID list: 400-402, 404
Command output
1.
Field
Mode
Local use
Remote use
ECT-Index
Algorithm
Mask
I-SID list

display spbm bridge

Use display spbm bridge to display SPBM bridge information.
Remote use: No
Algorithm: 00-80-c2-01
Remote use: No
Algorithm: 00-80-c2-01
Description
System operating mode. This field displays SPBM for an SPBM-enabled device.
Availability of the B-VLAN for transmitting traffic at the local end:
•
Yes—The B-VLAN can transmit traffic.
•
No—The B-VLAN cannot transmit traffic.
Availability of the B-VLAN for transmitting traffic at the remote end:
•
Yes—The B-VLAN can transmit traffic.
•
No—The B-VLAN cannot transmit traffic.
ECT algorithm index.
ECT algorithm content.
ECT algorithm mask.
I-SIDs mapped to the B-VLAN on the local device.
This field displays N/A if no I-SIDs are mapped to the B-VLAN.
14
Mask: 0x00
Mask: 0x00