HP FlexFabric 5930 Series Command Reference Manual page 48

System name
Bridge priority
SPSource ID
SPSource mode
Agreement mode
MCID information:
Format selector
Region name
Revision level
Configuration digest : 0x0253c1480d244e443b21e7c364d6e2a7
B-VLANs
Command output
1.
Field
Area address
System ID
System control address
System name
Bridge priority
SPSource ID
SPSource mode
Agreement mode
B-VLANs
MCID information
Format selector
Region name
Revision level
: spb-1
: 32768
: 200
: Static
: Both
: 0
: spb
: 0
: 1-10, 100-200
Description
ISIS-SPB area address of the device.
System ID of the device in the ISIS-SPB area.
Multicast destination for ISIS-SPB protocol packets.
Hostname configured with the is-name command.
SPBM bridge priority of the device. In conjunction with the system ID, the SPBM
bridge priority forms the SPBM bridge ID. The SPBM bridge ID is a tie-breaker
used in the ECT algorithms for choosing shortest paths.
Shortest path source identifier uniquely identifies the device as a multicast source
in an SPBM VSI. In conjunction with the I-SID, the SPSource ID forms the multicast
address of the device in an SPBM VSI.
SPSource ID creation method:
•
Static—The SPSource ID is manually configured.
•
Dynamic—The SPSource ID is dynamically assigned by ISIS-SPB.
AP mode:
•
Both—AP is enabled for both unicast and multicast FDB entries. The device
issues a unicast or multicast FDB entry to the FIB for forwarding traffic only if
it has reached an agreement with the neighbor.
•
Multicast—AP is enabled only for multicast. The node forwards multicast
traffic only after the two ends reach a strict agreement. However, the node
forwards unicast traffic unconditionally.
•
Off—AP is disabled. Digests are exchanged but a match is not required.
B-VLANs configured on the device.
Local primary MST configuration identifier. It contains a digest of B-VLAN to
MSTI mappings on the SPBM node. SPBM nodes must have the same MCID for
the same I-SID.
Format selector. It is fixed at 0 for IEEE 802.1aq SPB.
MST region name.
MST region revision level. The default level is 0. You can use the revision-level
command to change the revision level.
44