Advertisement
If method A has resulted in poor fitment of side trims due to cabinet being out of spec, use method B.
IMPORTANT!
Before installing your appliance, ensure the dimensions of the finished enclosure are
correct for your appliance following the 'Product and cavity dimensions' sections.
Break off the datum lip to each side
1
trim bracket and discard.
Repeat for all side trim brackets.
For 2032mm cavity installation only
Measure 102mm from the top, shorter side trim and
2
carefully cut using a fine tooth hacksaw to a length
of 1930mm. Refer to A for orientation of side trim.
Note: ensure cut is straight and square as this is an
exposed surface. Also ensure the plastic part does
not bend as this can cause visual stress marks.
Repeat this process for the remaining side trim.
@1
ATTACH SIDE TRIM BRACKETS – (B) FIXED SCREW METHOD
Discard
A
Aluminium
Plastic
50mm
~
1753mm
~
1016mm
Front of
cabinet
~
254mm
B
0
Position three side trim brackets on each side (refer to B for bracket locations). Open the
3
appliance door. Measure 50mm from the front of refrigerator (from behind the door), to
the front of the alcove and accurately mark a vertical line (refer to C).
Align the bracket edge with the marked line and using screws x2 (#8 x 16 mush washer)
fix the bracket to the cabinetry x3.
Repeat on the opposite side.
IMPORTANT!
Inaccurate positioning of bracket can result in inability to fit side trim or gaps between
side trim and appliance.
C
33
Advertisement
