If applicable, remove any remaining protective
1
film on your door panels.
A
Open the refrigerator door, firmly push
2
top cover (refer to A) over the top studs.
Door side trims
3
Install the side trims by inserting into the panel gaps on each side of the door (refer to B).
Align the trim to the top of the door and press evenly into the panel gap until fully seated
(refer to C).
28
!8
ATTACH COVERS
B
C
D
E
Press the 3M Dual Lock™ tabs together to form pairs (refer to D) and remove the adhesive
4
backing on one side only.
Press firmly to install on the underside of the drawer top trim in the indicated locations
(refer to E).
Drawer side trims
5
Install the side trims in the same manner (refer to step
Drawer top trim
6
Remove the remaining adhesive backing from the 3M Dual Lock™ tabs. Locate the trim
against the back surface of the panel and press down firmly. Ensure the trim is fully seated
against the drawer surface.
).
3