Advertisement
For Fisher & Paykel EZKleen stainless steel door panels and custom panels.
IMPORTANT!
Remove protective film from white refrigerator
doors before hanging door panels.
Hang all door panels onto M8 studs and align
1
the side bracket forks onto the refrigerator door.
– Ensure the forks are positioned around the
body of the side screws (M5 x 10 pan head
Phillips screw).
Push the refrigerator until the door panels are
2
flush. Depending on your installation design this
will be flush with your adjacent cabinetry or
your framework. Place a ruler on the front of the
refrigerator to check flushness top and bottom,
left and right (refer to drawing below).
Ensure the gap between the top of the door
3
panel and the top cabinetry is no greater than
7mm. To reduce this gap, raise the refrigerator
by turning all four adjustment nuts the same
number of turns.
IMPORTANT!
Failure to follow these steps can lead to
difficulties in door panel adjustment and
cosmetic cap fitment.
Lock top panel side screw to allow
4
opening the door without affecting
adjustment.
!5
HANG NON-WATER DISPENSING DOOR PANELS
Place a ruler on the front of the
refrigerator to check flushness
top and bottom, left and right.
All door panels have full axis adjustment to ensure
5
they are flush with adjacent walls. To adjust the
height of each panel turn clockwise to raise stud or
counter-clockwise to lower stud (refer to A).
A
Once satisfied with all door panels, secure M8 studs
6
with M8 washer and M8 nut (refer to B). The top of the
stud must remain below the top face of the door panel.
C
D
Secure side bracket forks by tightening side screws (C).
7
Repeat this process for all door panels.
Note: for depth adjustment loosen side screws x4,
adjust panels and then retighten once satisfied.
Note: further adjustment of door panels can be achieved by removing door panels
then loosening the fixing screws for the hanging bracket and moving the bracket
sideways to suit.
Loosely install locking bracket into the pocket on the underside of the door using a
8
M8 stud (D). Slide the locking bracket out until it touches the back of the door panel.
Screw in place using a #8 x 16 screw through one of the three slotted holes. Fully
tighten the M8 stud.
B
25
Advertisement
