Advertisement
Thread the free end of the water line hose into the dedicated hole located in the base of the
5
refrigerator, through to the back of the refrigerator (refer to C).
At the back of the refrigerator, loosely coil the water line hose (
6
the end of the hose to the cold water supply (refer to D).
Take care not to over-tighten the connection. Turn the isolating tap on and check that all
connections are dry and free of drips.
20
!0
CONNECT TO WATER AND ELECTRICAL SUPPLY
D
C
~
2 – 3 times) and fasten
At the back of your refrigerator, connect the refrigerator to the electrical supply (230VAC,
7
50Hz) with the fitted plug and lead, and turn on. Ensure the refrigerator is connected to its
own isolating switch (refer to E).
F
In order to push refrigerator into correct position:
8
Stop midway, reach through base to locate power cord. Pull power cord through the front left
●
●
side of the refrigerator (refer to F), tucking it neatly in the left side of the base (refer to G).
Reach through base to locate water line hose coil. Tuck coil neatly into front right side of
●
●
base (refer to H).
IMPORTANT!
Failure to do this can result in running over the hose causing damage and possible
water leaks.
Push the refrigerator until the doors are in line with the frame. Ensure the refrigerator is
●
●
centred.
Firm contact must be achieved between the refrigerator and the anti-tip bracket,
●
●
min. 60mm overlap (refer to I ).
WARNING!
Failure to follow this instruction can lead to serious injury or death.
min. 60mm
overlap
I
E
G
H
Final location
Final location
of power cord,
of water tube,
left side of base
right side of base
Advertisement
