Advertisement
(B) FIXED SCREW METHOD – METHOD TO USE IF CABINET IS NOT TO SPECIFICATION
(Attempt method A. If method A results in poor fitment of side trims due to cabinetry that is uneven or out of specification, use method B).
IMPORTANT!
Before installing your refrigerator, ensure the dimensions of the finished enclosure are correct for your refrigerator following the 'Product and cavity dimensions' sections.
Break off the datum lip to each side
1
trim bracket and discard.
Repeat for all side trim brackets.
For 2032 mm cavity installation only
Measure 102mm from the top, shorter side trim and
2
carefully cut using a fine tooth hacksaw to a length
of 1930mm. Refer to A for orientation of side trim.
Note: ensure cut is straight and square as this is an
exposed surface. Also ensure the plastic part does
not bend as this can cause visual stress marks.
Repeat this process for the remaining side trim.
TWO METHODS ARE AVAILABLE FOR ATTACHING SIDE TRIM BRACKETS:
(A) FLEXIBLE SPRING CLIP METHOD – RECOMMENDED METHOD
@1
ATTACH SIDE TRIM BRACKETS – (A) FLEXIBLE SPRING CLIP METHOD
Discard
A
Aluminium
Plastic
Position 3 side trim brackets onto each side trim.
3
Note: measure from the top of the trim, with
the shorter lip at the bottom. (Refer to B for
2032mm and 2134mm bracket locations and trim
orientation).
IMPORTANT!
Each bracket has two engagement points for the
side trim to locate. Ensure the trim is engaged in
both points (refer to C).
Repeat this process for the remaining side trim.
Side trim
bracket
Side trim
Top view of side trim engaged
correctly in side trim bracket
0
2032mm = 229mm
2134mm = 330mm
2032mm = 914mm
2134mm = 1016mm
C
2032mm = 1651mm
2134mm = 1753mm
B
31
Advertisement
