Advertisement
The assembly of Fisher & Paykel (EZKleen stainless steel) door panels and custom door panels are outlined below. To protect the finish of the Fisher & Paykel EZKleen stainless steel door panels,
leave the protective film on the panels when hanging and remove the film only when the installation is complete.
If using custom door panels, ensure they are prepared as per 'Custom door panel dimensions' section.
Door panel
Mounting handle (refer to A)
1
For Fisher & Paykel door panel sets, remove the
plastic plugs from the handle holes x4. Align
the handle to the holes and secure with screw
handle x4 (M5 x 25 pan head socket screws).
For custom panels, ensure handle is secured
65mm from the inner edge of the panel to the
centre – this will avoid interference with bracket
installation.
Hanging bracket (refer to B)
2
For Fisher & Paykel door panel sets, align the
bracket to the holes and secure with screws x6
(M5 x 14 Mush Phillips SS).
For custom panels, secure bracket with screws
x6 (#8 x 16 Mush washer screws).
Side brackets and straps (refer to C)
3
For Fisher & Paykel door panel sets, align
bracket and strap to the holes on the side of
the panel and secure with screws x2 (M5 x 14
Mush Phillips SS).
For custom panels, secure bracket with
screws x2 (#8 x 16 Mush
washer screws).
Repeat this
process for all
brackets and
straps.
!3
B
C
ASSEMBLE DOOR PANEL SET
Drawer door panel
Mounting handle (refer to D)
4
For Fisher & Paykel door panel sets, remove
the plastic plugs from the handle holes x4.
Align the handle to the holes and secure with
screw handle x4 (M5 x 25 pan head socket
screws).
For custom panels, ensure handle screw heads
are counter sunk into the back of the panel to
avoid interference with hanging bracket.
A
Hanging bracket (refer to E)
5
For Fisher & Paykel door panel sets, align the
bracket to the holes and secure with screws x6
(M5 x 14 Mush Phillips SS).
For custom panels, secure bracket with screws
x6 (#8 x 16 Mush washer screws).
Side brackets and straps (refer to F)
6
For Fisher & Paykel door panel sets, align
bracket and strap to the holes on the side of
the panel and secure with screws x2 (M5 x 14
Mush Phillips SS).
For custom panels, secure bracket with screws
x2 (#8 x 16 Mush washer screws).
Repeat this process for all brackets and
straps.
D
E
F
23
Advertisement
