Gts Commands; Display Qos Gts Interface - HPE FlexFabric 5940 Series Command Reference Manual

The conforming traffic is permitted to pass through, and the excess traffic is dropped.
If you execute the qos car command multiple times for the same user profile, the most recent
configuration takes effect.
Examples
# Perform CAR for packets received by user profile user. The CAR parameters are as follows:
•
The CIR is 200 kbps.
•
The CBS is 51200 bytes.
<Sysname> system-view
[Sysname] user-profile user
[Sysname-user-profile-user] qos car outbound any cir 200 cbs 51200

GTS commands

display qos gts interface

Use display qos gts interface to display the GTS information for interfaces.
Syntax
display qos gts interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays the GTS information for all interfaces.
Examples
# Display the GTS information for all interfaces.
<Sysname> display qos gts interface
Interface: Ten-GigabitEthernet1/0/1
Rule: If-match acl 2001
CIR 200 (kbps), CBS 50000 (Bytes), PIR 55000 (kbps), EBS 0 (Bytes)
Queue Length: 100 (Packets)
Queue Size: 70 (Packets)
Passed
Discarded: 0 (Packets) 0 (Bytes)
Delayed
Interface: Ten-GigabitEthernet1/0/2
Rule: If-match acl 2001
CIR 50 (kbps), CBS 600 (Bytes), EBS 0 (Bytes)
Queue Length: 100 (Packets)
Queue Size: 70 (Packets)
Passed
: 0 (Packets) 0 (Bytes)
: 0 (Packets) 0 (Bytes)
: 0 (Packets) 0 (Bytes)
78