Qcn Priority - HPE FlexFabric 5940 Series Command Reference Manual

auto: Configures the interface to negotiate the defense mode by using LLDP.
Usage guidelines
If a device is not assigned to a CND, you cannot configure this command on its interfaces.
The CND settings for an interface take precedence over the global CND settings.
Examples
# Configure defense mode disabled and alternate value 0 for Ten-GigabitEthernet 1/0/1 in the CND
with CNPV 1.
<Sysname> system-view
[Sysname] qcn priority 1 auto
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qcn port priority 1 admin defense-mode disabled
alternate 0
# Configure Ten-GigabitEthernet 1/0/2 to negotiate the defense mode by using LLDP.
<Sysname> system-view
[Sysname] qcn priority 2 admin
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] qcn port priority 2 auto
Related commands

qcn priority

qcn priority
Use qcn priority to configure global CND settings.
Use undo qcn priority to remove a device from a CND and delete all settings in that CND.
Syntax
qcn priority priority { admin [ defense-mode { disabled | edge | interior | interior-ready }
alternate alternate-value ] | auto }
undo qcn priority priority
Default
A device does not belong to any CND.
Views
System view
Predefined user roles
network-admin
Parameters
priority: Specifies a priority value as the CNPV, in the range of 0 to 7. The CNPV cannot be equal to
the alternate value configured globally or for interfaces.
admin: Configures the device to use a user-configured defense mode.
defense-mode: Configures a defense mode. By default, the interior defense mode is used.
disabled: Specifies the disabled defense mode. This mode disables congestion notification and
performs priority mapping according to the priority mapping table.
edge: Specifies the edge defense mode. This mode maps the specified CNPV of frames to an
alternate value.
124