Download  Print this page

Assembling Your Bowl-Lift Mixer - KitchenAid 4KB25G1XBU3 Instructions & Recipes

Bowl-lift stand mixer
Hide thumbs

Advertisement

Table of Contents

Assembling Your Bowl-Lift Mixer

Electrical Shock Hazard
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
To Attach Bowl
1. Turn speed control to OFF.
2. Unplug stand mixer.
3. Place bowl-lift handle in down
position.
4. Fit bowl supports over locating
pins.
5. Press down on back of bowl
until bowl pin snaps into spring
latch.
6. Raise bowl before mixing.
7. Plug into a grounded 3 prong
outlet.
To Raise Bowl
1. Rotate handle to straight-up
position.
2. Bowl must always be in raised,
locked position when mixing.
To Lower Bowl
1. Rotate handle back and down.
To Remove Bowl
1. Turn speed control to OFF.
2. Unplug stand mixer.
3. Place bowl-lift handle in down
position.
4. Remove flat beater, wire whip,
or spiral dough hook.
5. Grasp bowl handle and lift
straight up and off locating pins.
To Attach Flat Beater,
Wire Whip, or PowerKnead™
Spiral Dough Hook
1. Turn speed control to OFF.
2. Unplug stand mixer.
3. Slip flat beater on beater shaft.
4. Turn beater to the right, hooking
beater over the pin on shaft.
5. Plug into a grounded 3 prong
outlet.
To Remove Flat Beater,
Wire Whip, or PowerKnead™
Spiral Dough Hook
1. Turn speed control to OFF.
2. Unplug stand mixer.
3. Press beater upward and turn to
the left.
4. Pull beater from beater shaft.
Raise
5
Pin

Advertisement

Table of Contents
loading