Assembling Your Bowl Lift Stand Mixer - KitchenAid 5KSM7580XC Instructions Manual

ASSEMBLING YOUR BOWL LIFT STAND MIXER

Electrical Shock Hazard
Plug into an earthed outlet.
Do not remove earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in
death, fire, or electrical shock.
To Attach Bowl
1. Turn speed control to "0" (Off).
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl lift lever in down position.
4. Fit bowl supports over locating pins.
5. Press down on back of bowl until
bowl pin snaps into spring latch.
6. Raise bowl before mixing.
7. Plug into a grounded outlet
or reconnect power.
To Remove Bowl
1. Turn speed control to "0" (Off).
2. Unplug Stand Mixer or disconnect
power.
3. Place bowl lift lever in down position
4. Remove flat beater, wire whip, or
dough hook.
5. Grasp bowl handle and lift straight
up and off locating pins.
To Raise Bowl
1. Rotate lever to straight-up position.
2. Bowl must always be in raised, locked
position when mixing.
W11266857B.indb 11
To Lower Bowl
1. Rotate lever back and down.
To Attach Flat Beater, Wire Whip,
or Dough Hook
1. Turn speed control to "0" (Off).
2. Unplug Stand Mixer or disconnect
power.
3. Slip flat beater
on beater shaft
and press upward
as far as possible.
4. Turn beater to right,
hooking beater over the pin on shaft.
5. Plug into a grounded outlet or
reconnect power.
To Remove Flat Beater, Wire Whip,
or Dough Hook
1. Turn speed control to "0" (Off).
2. Unplug Stand Mixer or disconnect
power.
3. Press beater upward as far as possible
and turn left.
4. Pull beater from beater shaft.
5. Plug into a grounded outlet
or reconnect power.
Stand Mixer Speed Control and Lever
Guard
The Stand Mixer has a feature that
minimizes splash-out by starting the
mixer slowly before increasing to the
selected speed. To further reduce the
potential for splash-out, always begin
mixing using speed 1, then gradually
move to higher speeds as needed.
See "Speed Control Guide."
Auto-Reset Motor Protection
If the Stand Mixer stops due to overload,
slide the speed control lever to "0"
(Off). After a few minutes, the stand
mixer will automatically reset. Slide the
speed control lever to the desired speed
and continue mixing. If the Stand Mixer
does not restart, see "Troubleshooting
Problems."
ASSEMBLING YOUR BOWL LIFT STAND MIXER | 11
11/13/2018 1:05:57 PM