Parameters For Tig Welding - Fronius AccuPocket 150/400 Operating Instructions Manual

Parameter
Parameters for
Parameter
TIG welding
34
Description
Software version
The full version number of the currently installed
software is contained in a number of displays and
can be retrieved by turning the adjusting dial.
Automatic switch-off (time Shut down)
If the device is not used or operated for a specified
period of time, it switches off automatically.
Factory setting: 900 seconds
Factory setting (FACtory)
This can be used to reset the device to its factory
settings.
- Cancel reset
- Reset the parameters for the selected weld-
ing process to their factory settings
- Reset the parameters for all welding process-
es to their factory settings
Resetting of the selected value to its factory set-
ting must be confirmed by pressing the adjusting
dial.
Description
Comfort Stop Sensitivity
This parameter is only available when the tri pa-
rameter is set to OFF.
Factory setting: 2.0
For details see section "TIG Comfort Stop"
page 31
Break voltage (U cut off)
Used to specify at which arc length the welding
process is completed.
The welding voltage increases as the length of the
arc increases. The arc is extinguished when it
reaches the voltage specified here.
This parameter is only available when the tri and
CSS parameters are set to OFF.
Factory setting: 15 V
Software version
The full version number of the currently installed
software is contained in a number of displays and
can be retrieved by turning the adjusting dial.
Automatic switch-off (time Shut down)
If the device is not used or operated for a specified
period of time, it switches off automatically.
Factory setting: 900 seconds
Range Unit
300 - 900 Seconds
OFF
no
YES
ALL
Range Unit
0.3 - 2.0 Volt
OFF
on
12 - 35 Volt
300 - 900 Seconds
OFF