No Function - Fronius AccuPocket 150/400 Operating Instructions Manual

Make a note of the error numbers shown in the display, and of the serial number and con-
figuration of the power source, and contact our after-sales service team with a detailed de-
scription of the error.
E02 / E03 / E05 / E06
Cause:
Remedy:
E07
Cause:
Remedy:
E09 / E10
Cause:
Remedy:
E11
Cause:
Remedy:
E12 / E13 /E14
Cause:
Remedy:
E16
Cause:
Remedy:
E018
Cause:
Remedy:
E19 / E22
Cause:
Remedy:
E23
Cause:
Remedy:

No function

The device cannot be switched on
Cause:
Remedy:
Cause:
Remedy:
Internal temperature sensor fault on ACCUPLT / ACCUPLT-TIG PC board
Contact after-sales service
15 V supply voltage too low
Contact after-sales service
Impedance load too high on power source output
Use power source correctly (welding)
No communication with the control panel
Contact after-sales service
Internal error on ACCUPLT / ACCUPLT-TIG PC board
Contact after-sales service
Communication error between battery and ACCUPLT / ACCUPLT-TIG PC
board
Contact after-sales service
Wrong firmware (software) has been loaded
Contact after-sales service
Battery fault
Contact after-sales service
A voltage of > 113 V DC has been measured on the welding sockets
Contact after-sales service
The battery has entered a state of deep discharge as it has been stored for
too long without being charged
Charge the battery now
Battery operation is possible again above 25% capacity.
If charging is no longer possible, contact After-Sales Service.
Control panel defective
Contact After-Sales Service
39