Banner GM-FA-10J Original Instructions Manual page 20

LED Condition
Input 1 ON
(green)
OFF
Flashing (along with the Fault
LED ON)
Input 2 ON
(green)
OFF
Flashing (along with the Fault
LED ON)
Output ON
(green)
OFF
Flashing
Flashing (along with the Fault
LED ON)
Clearing Faults
To clear a fault condition, first correct the problem and then cycle the input channels to the module (open and close the guards). When
the Fault LED lights, the corresponding Function LED will flash to indicate the problem. If the Fault LED is flashing, refer to
page 19.
Input 1: S12/S13
Input 2: S22/S23
LED
Power ON
Fault ON
Input 1 FLASHING
Input 2 ON or OFF
Output OFF
Power ON
Fault ON
Input 1 ON or OFF
Input 2 FLASHING
Output OFF
Power ON
Fault ON
Input 1 FLASHING
Input 2 FLASHING
Output OFF
Power ON
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Meaning
Guard 1 is closed and the inputs of Channel 1 are satisfied.
Guard 1 is open or the inputs of Channel 1 are not satisfied.
See Clearing Faults on page 20 for probable cause.
Guard 2 is closed and the inputs of Channel 2 are satisfied.
Guard 2 is open or the inputs of Channel 2 are not satisfied.
See Clearing Faults on page 20 for probable cause.
Both internal relays K1 and K2 are energized (13/14 and 23/24 are closed).
Both internal relays K1 and K2 are de-energized (13/14 and 23/24 are opened).
Reset requested. Cycle the Reset input (button) (open, closed, open) to enter RUN
mode.
See Clearing Faults on page 20 for probable cause.
Fault, Probably Cause, and Procedures
INPUT CHANNEL 1 FAULT (S11/S12/S13)
a. S13 Open (guard closed)
b. S12 Open (guard open)
c. S11 Open (guard is open or closed)
d. Short between S11 and S12
INPUT CHANNEL 2 FAULT (S21/S22/S23)
a. S23 Open (guard closed)
b. S22 Open (guard open)
c. S21 Open (guard is open or closed)
d. Short between S21 and S22
SHORT BETWEEN INPUT CHANNELS
a. Short between S11 and S21
SIMULTANEITY FAULT
GM-FA-10J Gate Monitoring Safety Module
Repairs on