Installing The Drive Cage - Harmonic Omneon MediaDeck Component Replacement Manual

Figure 11 Removing the Drive Cage

Installing the Drive Cage

To install the drive cage:
1. Unpack the drive cage.
2. Making sure the chassis is adequately braced, grip the front of the
drive cage with both hands and slide it into the chassis until the
front of the drive cage is flush with the chassis.
NOTE: Make sure the drive cage is aligned properly; the front panel
LED card should be in the lower right-hand corner.
3. Tighten the left and right-hand captive screws.
NOTE: Do not over-tighten the captive screws.
4. Install each of the disk drives. Refer to
instructions.
5. Install the front bezel. Refer to
instructions.
6. Apply power to the Omneon MediaDeck by connecting the AC
power cords to the separate, isolated power sources.
Omneon, Now Part of Harmonic
Replacing the Drive Cage
Replacing a Disk Drive
Replacing the Bezel
for
for
21