Upgrading The Mediadeck Firmware; Checking The File System - Harmonic Omneon MediaDeck Component Replacement Manual

Upgrading the MediaDeck Firmware

Now that the new MediaDeck is connected, make sure that all the
MediaDecks and MediaDeck Modules in your system are running
the same version of firmware. If necessary, follow the instructions
in "Upgrading Firmware" in the Omneon MediaDeck™ User's Guide to
upgrade your MediaDeck and MediaDeck Module firmware. After
the upgrade, the new MediaDeck will need to be restarted. Once
you have verified that all the MediaDecks and MediaDeck Modules
in your system are running the same version of firmware, continue
to the next step.

Checking the File System

Once you have powered up the new MediaDeck, check the status of
the file system by doing the following:
1. From the Configuration tab in SystemManager, click the Disk
Utilities icon in the left-hand column. The Disk Utilities page
displays all MediaDecks or MediaDirectors on the network and the
status of their file systems.
2. Click on the name of the new MediaDeck. This will take you to the
Disk Utilities page for the new MediaDeck. There are two
columns displayed, the Physical View and Logical View. At the
top of the Logical View column, there is a link to the file system, as
shown in
Omneon, Now Part of Harmonic
Figure 20.
Replacing the Processor Module
39