Harmonic Omneon MediaDeck Component Replacement Manual page 16

Replacing the Bezel
To install the new bezel:
1. Unpack the bezel.
2. Align the bezel in front of the chassis so that the Omneon logo
appears in the top-left corner, and the metal corners of the bezel are
level with the rack ears of the chassis.
3. Keeping the corners aligned, press the bezel straight onto the
chassis. The top and bottom edges of the bezel should slide over the
top and bottom edges of the chassis. The LED connector inside the
bottom right-hand corner of the bezel should connect to the LED
card inside the chassis.
4. Hand-tighten the four captive thumb screws to secure the bezel in
place.
NOTE: Do not overtighten the thumb screws.
3
Figure 2 Installing the Bezel
6
4
Component Replacement Guide