Removing The Original Mediadeck From Systemmanager; Changing Vdhcp Settings - Harmonic Omneon MediaDeck Component Replacement Manual

Replacing the Processor Module
Removing the Original MediaDeck
from SystemManager
Now that you have moved the players to the new MediaDeck,
remove the original MediaDeck from SystemManager by doing the
following:
1. In SystemManager, click the Diagnostic tab, and then from the
left-hand column, click the Remove Device icon. The Remove
Devices page appears.
2. In the section for Not Responding, the original MediaDeck will be
shown. Using the drop-down menu, select the host for that
MediaDeck, and then click Remove until the MediaDeck no longer
appears.

Changing vDHCP Settings

NOTE: If you wish to use the same IP addresses on the new processor
module as on the original one, continue to
Module Using the Same IP Addresses
Once you have removed the original MediaDeck from
SystemManager, the vDHCP settings must be changed to match the
the Ethernet (MAC) addresses of the new MediaDeck.
1. Determine the MediaDeck's new IP and Ethernet (MAC) addresses
by doing the following:
a. From the System Diagram page in SystemManager, click the
MediaDeck heading (or icon) to open the Physical
Configuration page. Click the icon of the MediaDeck to
display the MediaDeck Properties page
b. In the Host Properties section of the MediaDeck Properties
page, make a note of both Host IP addresses and the
corresponding Ethernet (MAC) addresses.
44
Replacing a Processor
.
Component Replacement Guide