Table of Contents
Advertisement
Replacing a Disk Drive
9. Insert a replacement drive according to the following steps:
a. Open the latch on the front of the disk drive by pressing the tab
to the right while pulling the lever back as shown in
Note: Keep in mind that the lever should always open from the
right.
b. Using the slot guides in the enclosure to guide the drive, insert
the disk drive all the way into the drive bay until the camming
lever on the left side of the carrier stops it.
c. Gently push the camming lever towards the enclosure until it
clicks into a closed position.
Figure 4 Installing a Disk Drive
10. Within three minutes, the new drive should appear on the Disk
Utilities page on the SystemManager application. Verify that the
drive is reported as Alive by the Omneon MediaDeck. Continue to
Step
11.
If the drive is not reported as Alive by the Omneon MediaDeck,
bypass the drive (following the instructions in
drive, and replace with another drive if available. Repeat this step
and, if successful, continue to
12
B
C
A
Step
11.
Component Replacement Guide
Figure
Step
3), remove the
4a.
Hide quick links:
Advertisement
Table of Contents
