Installing The New I/O Module; Attaching The I/O Module To The Existing Players - Harmonic Omneon MediaDeck Component Replacement Manual

Replacing an I/O Module
4. From the Select column, click the check box for the I/O module
you wish to remove, and then click the Remove MediaPorts
button. When a confirmation message appears, click OK. After a
brief pause, a message appears indicating that the device has been
removed (it has also been removed from the System diagram).
5. Click OK to return to the Remove Device page.

Installing the New I/O Module

To install an I/O module:
1. Unpack the I/O module.
2. Using both hands to grip the rear panel of the I/O module, gently
slide the module into the chassis until the rear panel is flush with the
rear of the chassis.
3. Using a screwdriver, tighten the three screws on the rear panel of
the I/O module.
NOTE: Do not over-tighten the screws.
4. From the Configuration tab of SystemManager, view the System
Diagram page and verify that the new I/O module appears.
5. Connect any necessary cables to the I/O module. Refer to the
Omneon MediaDeck™ Installation Guide for instructions.
Attaching the I/O Module to the Existing
Players
Once you have installed the new I/O module, use the Attach
Devices feature in SystemManager to attach the I/O module to the
existing players.
28 Component Replacement Guide